Turblown FD3S Throttle Body Elbow Year_1986-1988 1.3L (13BRE) Turbo

Turblown FD3S Throttle Body Elbow Year_1986-1988 1.3L (13BRE) TurboTurblown Cast Aluminum FD3S Rx7 throttle body elbow. This unit features an air splitter internally to properly channel the incoming air evenly to the OEM FD3S throttle body. It has one bung available for a air temp sensor( not tapped or drilled out). 3" intercooler piping with a 90 degree entrance which removes common harsher bends found on most elbows. This unit may interfere with certain strut tower braces. This does clear the OEM cruise control

This kit does require an upgraded alternator of at least 100 amps( like the FD unit

800 gold box ECUs)

This might require new intercooler hot side piping possibly

and limits engine expansion

This kit uses the OEM FD3S water pump housing and oem thermostat(This does not require an alternator relocation bracket

Plug 'n' Play replacement of the factory ECU for Mazda RX7 FD3S-S6 (92-95) 2 row ECU plug

We are currently in dyno testing phase with our sample sideport units

– Brackets from Electroless Nickel plated 10 gauge 1018 CR Steel

All oem emissions removed( for off road use only**)

the equivalent of approximately one teaspoon before requiring replacement

SFI Spec 1

Requires OE counterweight